Winsetup Vista Patch Windows 10 Install ISO

Winsetup Vista Patch Windows 10 Install ISO

You can use any UEFI-bootable source for the WinPE - e.g. Windows 10 Install ISO (the sourcesinstall.wim file can be removed).

You can use SDICHOCO or other XML files (XML files can be generated on WAFG website ).

The BOOT PART in red means that the partition is not marked active (bootable) and it should be.

This folder already exists on the E2B drive and contains additional useful files.

Make a text file containing the diskpart commands which you can use to wipe and partition the target hard disk.

See here for some GPT examples and here for some MBR examples.

Here is one I used to partition Disk 0 as a GPT disk ready for a UEFI install.

ISOdocsE2B Utilities WinNTSetuptoolsdiskpartDiskPartGPT.scr select disk 0.

E2B also contains some additional sample diskpart script files.

If you only have one disk in the system, the Disk1xxxx files will erase the E2B USB drive I use the Disk1xxxx files when booting from an E2B USB drive under VirtualBoxVMUB.

Under VBoxVMUB, Disk 0 is the USB drive and Disk 1 is the Virtual Machine Hard disk, so I must use the Disk1xxxx files under Virtual Box.

This will automatically load the ISO into WinNTSetup for you.

You can select a different ISO (e.g.

Win7 ISO) if you wish.

This can be the same ISO that you are going to install from or a different one (I suggest using the latest Win10 ISO because it is likely to contain the latest drivers).

You can use any of the ISOs in the ISOWINDOWSxxx folders or just copy a Windows Install ISO to any one of the other standard menu folders (e.g.

ISOMAINMENU). You can boot to almost any WinPE 8 or 10 ISO (e.g.

ChrisRs WinPESE ISOs, DLC ISOs, Gandalf ISOs, etc.).

It can be a 32-bit or 64-bit ISO.

Do NOT boot from a Windows 7 ISO because it wont have modern chipset or USB 3 support.

If SHIFTF10 does not work, proceed to the next Setup screen and try it again.

In my case I selected one of the ZZDangerxxxxxxSDICHOCO.XML files.

Note that if the XML file contains a drive partition section, it will be ignored, so the partitions will remain unchanged.

You can tick the Restart option if you wish and it will automatically reboot afterwards.

Otherwise you may find that the target system will try to reboot from the E2B drive.

Then use CtrlL to load the same configuration file for the next time.

If you want to run a specific WinNTSetup command line then you can use the STARTUP variable in a.mnu file to specify a different batch file which you can modify however you wish.

Also you (or the command line parameters) must specify which Edition (wim index number) you want to install - it is not controlled by the XML file.

You can use any UEFI-bootable source for the WinPE - e.g.

Windows 10 Install ISO (the sourcesinstall.wim file can be removed).

Winsetup.Dll Vista Patch